Error checkin

Carlos · Post by **Carlos** » Thu Mar 10, 2005 10:23 pm

I m using Vault Sever/Client 3.0.4. I was waorking on my project, then, I decided to check in everything(that was used). The checkin command was in the conextmenu, but checkin in did not make any changes, I had to checkin file by file. What ahppened?

Thanks.

lbauer · Post by **lbauer** » Fri Mar 11, 2005 8:57 am

Were there any error messages in the messages tab when you tried to checkin your changes?

Is it possible that there was a conflict in the pending change set, such as trying to edit and rename a file in the same changeset?

If one item in the changeset has a problem, nothing in the changeset gets committed.

Carlos · Post by **Carlos** » Fri Mar 11, 2005 9:56 am

No. there were no error messages. When I checked in one by one there were no errors. What could the problem had been?

lbauer · Post by **lbauer** » Fri Mar 11, 2005 10:39 am

It's hard to say at this point. It could have been a conflict in the change set.

How did you try to "checkin everything."? Did you try to commit the pending change set, checkin a folder or checkin a list of highlighted files?

Can you reproduce the problem? If so, let us know the steps you took leading up to it.