"Access Failure"

zumafan · Post by **zumafan** » Tue Jan 04, 2005 5:53 pm

Sometimes when checking out a group of files in VS2K3, VS works for a bit and then a small dialog box comes up that says: "Access Failure". and that's it.

Some of the files are then checked out, and others are not, but there is no follow-up on this error at all, it just stops the check out procedure !?

dan · Post by **dan** » Wed Jan 05, 2005 8:21 am

It might be that the IDE is trying to overwrite a file that is open and locked. Check the output pane in VS to see whether this is the case, or see http://support.sourcegear.com/viewtopic.php?t=249 for a discussion of a similiar problem.

zumafan · Post by **zumafan** » Wed Jan 05, 2005 11:01 am

There is nothing in the VS output pane.

It's not similar to the other issue you mentioned, plus the message that appears is "Access Failure", not "Access Denied".

dan · Post by **dan** » Wed Jan 05, 2005 3:56 pm

Are you on Vault 3.0? If so, send me your email, so I can get you a special build with extra logging in it.

zumafan · Post by **zumafan** » Wed Jan 05, 2005 5:10 pm

dan wrote:Are you on Vault 3.0? If so, send me your email, so I can get you a special build with extra logging in it.

Yes, we are on Sourcegear 3.0.1, I sent you my email privately.

SourceGear Support

"Access Failure"

"Access Failure"

Re: Access Failure